Instructions
iDye for Natural Fabrics instructions
How to dye natural fabrics with an iDye packet on the stove top or in a top or front loading washing machine.
An easy-to-use soluble dye packet for 100% natural fabrics. Each packet dyes 2 to 3 lb (1 to 1.3 kg) of dry fabric. Results vary with the fabric, the dye bath temperature and the dyeing time, so always test first. The dye bath is safe to pour down drains and into septic systems.
Which iDye?
- 100% natural fabrics: use iDye for Natural Fabrics.
- 100% polyester and nylon: use iDye Poly.
- Blends of natural and synthetic fibers: combine similar colors of iDye for Natural Fabrics and iDye Poly.
For best results
- Read all the instructions before you start.
- For the best results and most intense color, use the stove top method.
- Stir constantly for even color.
- For lighter shades, use less dye.
Stove top method
Note: don't use the utensils or pot for food afterwards.
1. Fill a stainless steel or enamel pot with enough warm water for the fabric to move freely. Turn the heat to medium.
2. Add the iDye packet to the water and stir until it's fully dissolved.
3. For cotton, linen and rayon, dissolve 1 cup (270 g) of non-iodized salt in a little hot water and add it to the dye bath. For silk, add ⅓ cup (78 ml) of white vinegar instead of salt. Avoid pouring it directly onto the fabric.
4. Add the pre-wetted fabric and raise the temperature to a simmer, just below boiling (185°F).
5. Keep it at a simmer and stir frequently for half an hour.
6. Turn off the heat and remove the fabric from the dye bath. Be careful, as the fabric and dye bath will be hot. Wear gloves, since leftover dye can stain skin.
7. Wash the fabric in cool water with a mild detergent and dry.
Top loading washing machine method
1. Fill the washing machine with just enough hot water for the fabric to move freely.
2. Add the iDye packet and agitate for 30 seconds or longer, until the packet dissolves.
3. For cotton, linen and rayon, add 1 cup (270 g) of non-iodized salt. For silk, add ⅓ cup (78 ml) of white vinegar.
4. Add the pre-wetted fabric.
5. Extend the dyeing time by resetting the wash cycle before the rinse cycle starts. The longer the dyeing time, the darker the color and the better the fixation. We recommend 50 to 60 minutes of dyeing time.
6. Let the cycle finish.
7. Wash the garment in cold water with a mild detergent and dry.
Note: most washers hold some water in the outer tub at the end of a cycle. After dyeing, run a short wash/rinse cycle with your normal detergent to remove any leftover color. If you have hard water, also wipe down the inside of the tub, since soap scum can build up and hold onto dye.
Front loading washing machine method
1. Dissolve the iDye packet in about two cups of hot water.
2. For cotton, linen and rayon, dissolve 1 cup of non-iodized salt in about a quart of hot water. For silk, use ⅓ cup of white vinegar instead of salt.
3. Pour the dissolved iDye and the dissolved salt or vinegar into the bottom of the washing machine tub. If your machine has a pre-wash flush, add the dye between the flush and wash cycles.
4. Add the pre-wetted fabric.
5. Set the machine to the hottest water and longest wash cycle, and extend the cycle if you can. The longer the fabric stays in the wash/dye cycle, the darker the color and the better the fixation.
6. When the wash cycle is done, let the machine finish the rest of the wash/rinse/spin cycle.
7. Wash the garment in cold water with a mild detergent and dry.
Note: clean your washer thoroughly after dyeing. Most front loading washers collect water in the door gasket and hold water in the outer tub. Wipe down the door gasket carefully and run a short cycle with your normal detergent. Your washing machine manual may have cleaning instructions.
Polyester blends
Choose the iDye Poly color closest to the iDye color you're using and add both packets to the dye bath. Follow the stove top method, letting the dye bath simmer for ½ to 1 hour.
Cotton and silk blends
If you're dyeing a cotton and silk blend and aren't sure whether to add salt or vinegar, you have three options:
- It's not critical: either salt or vinegar will work, so just pick one.
- Add neither, but use plenty of heat in the dye bath (stove top method).
- Do two separate dye baths, one with salt and one with vinegar. This is probably best for the darkest colors.